Documenting the restoration of my growing collection of classic Mustangs
It’s finally sunny here in Washington. With the new power steering installed, the roads are calling. Top down, practicing social distancing to the sound of the engine. But the cover to the top (the boot) won’t fit. This is harshing my buzz.
Continue reading “Convertible Boot Woes”
Picking up from the last post, I managed to get the distributor out, but not in any reusable state. As a reminder, here is where I left off.
Continue reading “Next Steps with the Engine”
When I bought the convertible, it had an issue with vibrations around 50 mph. I thought it might be related to the suspension and bad alignment that was evident with the wear pattern on the front passenger side tire. When I replaced the brakes with disc and refreshed the front end, I expected the vibration to go away, but it didn’t. With everything else replaced, the only part left is the power steering, so now its time to rebuild that.
Continue reading “Restoring Original Power Steering”
The intermittent wiper function of the convertible isn’t working, so I took this as an opportunity to pull the pump and see what’s going on. This is a follow up to add more detail to my previous post on rebuilding the pump found here.
Continue reading “67 Washer Pump Follow Up”
While the convertible is pretty solid, it does have a few items that need attention. The most pressing is the convertible top. It is pretty ragged and has several holes in it. While it is a summer car and the top is down for the most part, its pretty important to me to have a structurally sound top for the times where unexpected weather happens, or even just needing to park it outside over night at some point. So, that’s project number one.
Continue reading “New Convertible Top”
The dash lights on the convertible don’t work. The bezel is faded with the chrome areas turned to faded grey and peeling. The lenses are fogged, though not as bad as my coupe was. All of this combined tells me it’s a good project to replace some parts and see why the lights aren’t working. Maybe some upgraded bulbs along the way.
Continue reading “New Instrument Bezel and Lenses”
Digging into the convertible, I found a manual choke pull lever under the dash. On the carburetor end, I found a bent cable and a poorly operating choke. Combine this with an early 70’s cable throttle and a jury rigged gas pedal, and I found my next project.
Continue reading “Carburetor and Pedal Replacement”
When I picked up the convertible, the front end shook and it was nearly uncontrollable when I hit a pothole. The pothole problem turned out to be the front right lower control arm not being tightened down, so the camber went all over with every bump. After fixing that, it still shakes. I decided to get a fresh starting point by replacing the control arms, the strut rods, the spring perches, and the idler arm. I think the shake may be the idler, so I will replace that first and give it a test drive. I ordered all the parts at once though, so no waiting a week in between for parts.
Continue reading “CSRP Stock Style Disc Brakes”
Brad Albrecht's Mustang Restoration Projects 